TPS54318: TPS54318RTET

Bhadresh Patel

Part Number: TPS54318

We are planning to use below part in our design but meanwhile also we are checked simulation in TINA but showing some error in this simulation when we run dc analysis table so please help to get the resolve this issue.

TPS54318RTET

Error showing like below image]

over 5 years ago

0 Davor Pavlovski over 5 years ago

TI__Expert 3611 points

Hi,

Can you send the simulation file?

Regards,
Davor

0 Bhadresh Patel over 5 years ago in reply to Davor Pavlovski

Prodigy 90 points

Hi Davor,

Please find attached simulation file.

slvm651 - autosave 21-03-15 14_26.TSC

0 Davor Pavlovski over 5 years ago in reply to Bhadresh Patel

TI__Expert 3611 points

Thank you for sending the file. It seems correct to me, I will send it to our simulation experts for them to find the problem.
I will write back as soon as I have news from them.

Regards,
Davor

+1 Davor Pavlovski over 5 years ago in reply to Davor Pavlovski

TI__Expert 3611 points

Hi,

The reason why the DC analysis is not working is because this is a transient model. I ran the transient simulation and it gave me good results. So you can get the results in steady state once the transient at start-up has finished.

Regards,
Davor

0 Bhadresh Patel over 5 years ago in reply to Davor Pavlovski

Prodigy 90 points

Thanks Davor,

I have done simulation through Pspice model so thank for your time.

Power management

Power management forum

TPS54318: TPS54318RTET