Hi, Support Team
Customers are developing products using the TPS25200.
I am trying to not use the FAULT pin during development,
Can I just leave the pin as NC when not in use?
Or does it require separate processing?
Thanks.
Regards,
MJ
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi, Support Team
Customers are developing products using the TPS25200.
I am trying to not use the FAULT pin during development,
Can I just leave the pin as NC when not in use?
Or does it require separate processing?
Thanks.
Regards,
MJ