Hi, Support Team
A customer is developing TWS Credle.
Inquiries were received during development by applying the TPS25200.
In the circuit diagram below, a 10uF cap is connected to the 5V output of the TPS25200, and 4.7uF*2 is connected to the VDD terminal of the MCU.
[TPS25200]
[MCU 5V input]
Customers are concerned about surges or peaks because too high capacitance is applied to the 5V line.
Is the applied capacitance an appropriate capacitance?
I want to set the capacity of the cap connected to the 5V output of the TPS25200 to a lower value. How much is it possible?
Please confirm.
Thanks.
Regards,
MJ