TPS7A8101-Q1: Schematic review

Kygo Cheng

Expert 6830 points

Part Number: TPS7A8101-Q1

Hi Team,

There is a good new that DIN TPS7A8101-Q1

Please help check this SCH, THX

over 2 years ago

0 Srikanth Lolla Venkata over 2 years ago

TI__Genius 12040 points

Hello,

I will look into this and get back to you by the end of the day tomorrow.

Regards,

Srikanth

+1 Srikanth Lolla Venkata over 2 years ago in reply to Srikanth Lolla Venkata

TI__Genius 12040 points

Hello,

I think the schematic looks fine. Please ensure that C29 and/or C30 are connected in the circuit. For stability, it is recommended that an output Cap of magnitude 4.7uF or greater is connected. Your EN pin and NR pin are correctly connected in the schematic shown, but please note that it is slightly different in comparison to the actual footprint of the device, where after the IN pins, we have the NR pin and then the EN pin.

Regards,

Srikanth

Power management

Power management forum

TPS7A8101-Q1: Schematic review