Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: LP5860
Q1: Why are LP586x better solutions to drive Animated-Amounts-Autonomous (AAA) LEDs?
Q2: How to quickly set up the test environment for LP586x?
Q3: How to configurate PWM duty cycle and LED output current in the register panel…
Part Number: TPS54824 Other Parts Discussed in Thread: TPS54622 , , TPS54620 All 3 devices will have very similar or even identical transient response. There is not anything special done in the TPS54824 that will give it better transient response than…
Part Number: UCC21520
What should we take into account when changing a FET? What components should be modified and how could this affect our overall system performance?
Part Number: UCC21520
Noise is a long-standing enemy of high speed circuits. Whether it is noise on a power rail or at the gate of a power FET, noise can cause unpredictable behavior and even irreparable damage. Ferrite beads are one of the tools…
Part Number: TPS53353 Other Parts Discussed in Thread: TPS53355
With PGOOD pulled up externally to an MCU or FPGA and an external voltage source, I would not expect any issues in the soft-start/mode selection so long as the probe monitoring PGOOD is…
Other Parts Discussed in Thread: LMG1210 Hi,
I want to use the LMG1210 for a new design, but I want to make sure that I can manufacture the part for a few years to come. My question is when was the LMG1210 released and when will it reach it's end-of…
