Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TPS43330A-Q1 The boost controller allows the device to operate down to 2 V at the input; the duty cycle of Boost converter D = 1 – (input voltage/output voltage); so, it depends on your output voltage selection (7 V, 8.85 V, or 10 V), the…
Part Number: TPS6594-Q1
Yes, any BUCK feedback pin that is not being used for the BUCK feedback can be used as a voltage monitor. Unused feedback pins include FB_B3 on a 3-phase or 4-phase BUCK and FB_B4 on a 4-phase BUCK. Also, any feedback pins on…
Part Number: TPS6594-Q1
The TPS6594-Q1 and LP876x-Q1 devices have reprogrammable non-volatile memory. The memory can be updated over the device's I2C or SPI communication. This process is described in the "Scalable PMIC NVM Update Guide"
https://www…
Part Number: UCC21530-Q1
In order to improve efficiency and driving range, a major trend in electric vehicle is the increase of the battery voltage from 400V to 800V or higher. For the same reasons, 800V systems may also move from silicon-based IGBTs…
