Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] LP87745-Q1: Where can I find functional safety documents and full data sheet?

    Part Number: LP87745-Q1 The functional safety documents and full data sheet can be requested through following request link on product folder at https://www.ti.com/product/LP87745-Q1?keyMatch=LP8774-Q1 . Thanks!

  • [FAQ] LP87745-Q1: What is the naming convention of device part number?

    Part Number: LP87745-Q1 It is explained as following; LP8774 x x xx RXV R Q1 x : Number of regulators x : Switching Frequency (Fsw) and BOM/performance optimized options (1,2,or 3) LP8774x 1 : 17.6 MHz + full performance option or BOM/cost…

  • [FAQ] LP8758-B0: Can TI provide a solution size for the device?

    Part Number: LP8758-B0 Yes; the EVM design linked below can provide a reference of the solution size for these devices in every phase configurations: https://www.ti.com/tool/LP8758EVM?keyMatch=&tisearch=search-everything&usecase=hardware The picture…

  • [FAQ] LP8758-E0: Does TI have other existing OTP variants for quicker and easier samples?

    Part Number: LP8758-E0 Yes; listed in table picture below are existing OTP variants available for samples. Any new OTP variant needs to meet certain business size to start the process; please contact your local TI sales for more details.

  • [FAQ] LM26480: Is there a reference design of power up sequence implemented by RC delay on EN pin?

    Part Number: LM26480 Yes; a set of RC (Resistor and Capacitor) values were used on TI LM26480 EVM with VCC=3.3V on 3 "EN" pins (ENSW2, ENLDO1, ENLDO2) to control the power up delay for the sequence. ENSW1 connects to VCC directly without RC delay. …

  • [FAQ] BQ76952: Mask registers for Alarm Raw Status

    Part Number: BQ76952 Hi Team, I would like to ask a question: what is the mask registers? I am confused about the following words: Thanks a lot. BRs, Francis

  • [FAQ] TPS43330A-Q1: TPS43330 EMC Comparison between SS (Spread Spectrum) Disable/Enable

    Part Number: TPS43330A-Q1 TPS43330 EMC Comparison for SS.pdf

  • [FAQ] TPS43330-Q1: TPS43330/30A/2/3/5/6/7-Q1 Devices Difference

    Part Number: TPS43330-Q1

  • [FAQ] TPS43330-Q1: TPS43330/30A/2/3/5/6/7-Q1 Operation Mode Details

    Part Number: TPS43330-Q1

  • [FAQ] TPS43330A-Q1: What is the minimum possible duty cycle for the booster?

    Part Number: TPS43330A-Q1 The boost controller allows the device to operate down to 2 V at the input; the duty cycle of Boost converter D = 1 – (input voltage/output voltage); so, it depends on your output voltage selection (7 V, 8.85 V, or 10 V), the…

View FAQ threads