Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TPS6594-Q1
Yes, any BUCK feedback pin that is not being used for the BUCK feedback can be used as a voltage monitor. Unused feedback pins include FB_B3 on a 3-phase or 4-phase BUCK and FB_B4 on a 4-phase BUCK. Also, any feedback pins on…
Part Number: TPS6594-Q1
The TPS6594-Q1 and LP876x-Q1 devices have reprogrammable non-volatile memory. The memory can be updated over the device's I2C or SPI communication. This process is described in the "Scalable PMIC NVM Update Guide"
https://www…
Part Number: UCC21530-Q1
In order to improve efficiency and driving range, a major trend in electric vehicle is the increase of the battery voltage from 400V to 800V or higher. For the same reasons, 800V systems may also move from silicon-based IGBTs…
Part Number: TPS65910 The TPS65910 EEPROM is programmed ONLY in the factory during production.
The following documents (Snapshot from datasheet page96) describe the TPS65910 device use cases for particular processor by every variant.
Copies of these…
Part Number: LP8758-E0EVM Other Parts Discussed in Thread: LP8758 This Application Report provides more details about the different phase configuration variants of the LP8758 device.
Please feel free to ask any questions about the device for your application…
Part Number: TPS65023 Other Parts Discussed in Thread: , IPG-UI
This thread applies to the TPS65023 and TPS65023B devices.
When evaluating the TPS65023 or TPS65023B device using their respective evaluation module the most up to date software tool…