This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: UC3842A
I am referring to section 9.2.2 "Detailed Design Procedure" in document SLUS224E for the UC3842A device.
Equation 23 does not appear to be correct as it does not solve to the value shown in the example.
Rout is referenced in equation 23 but not defined.
Gco(f) is referenced in Equation 25, but is not defined anywhere in the document.
I would like to follow this procedure through to compensate the controller, but these issues make it difficult. Any help would be appreciated.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Bernard Keogh:
I checked with the datasheet author, datasheet updates are already in progress, and a new datasheet will be available online soon.
The corrections for the questions above may not make it onto the next/imminent release, if not they will be taken care of at a subsequent update.
Meanwhile, for the questions above, here are some clarifications/corrections:
For eqn. 23, Rout is the load impedance, Rout = Vout / Iout. At full load, Rout = 12 V / 4 A = 3 ohm.
Eqn. 23 has a small error, the Lpm used should be the secondary-referred magnetising inductance, or should include the term (Np / Ns)^2.
Since Np/Ns = 10, the secondary magnetising inductance will be 17 uH for primary inductance of 1.7 mH.
Eqn. 23 then evaluates to 9.7 kHz, rounded up to 10 kHz.
Gco(f) is an estimate of the control (Vc) to output transfer function, where variable Q is the quality factor:
Apologies for the confusion caused, I hope these clarifications help to answer your questions. If so, please click the "verify answer" button.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.