This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • Resolved

LMZ14202H reflow question

Prodigy 30 points

Replies: 2

Views: 206

We have parts on both sides of the pcb, so it needs to go through reflow twice, however the data sheet says this part can only go through reflow once.  How can that be?  Solutions?

  • The one time reflow requirement is to protect the solder joint inside the module. Do you have module on both sides of your board? Can you reflow the side without module first and reflow the module last?
    -Yang

    TI Wide Vin Buck Converter & Controller Applications Engineer

  • In reply to YangZhang:

    I think we are good, device is just on one side now.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.