BQ27441-G1: BQ27441-G1: Learning cycle in manual mode and Generating Golden image

Abhishek singh

Expert 2000 points

Part Number: BQ27441-G1
Other Parts Discussed in Thread: BQSTUDIO

Hi Team ,

I am trying to generate golden image for above-mentioned part hence performed learning cycle in manual mode in spite of getting FC bit set learning cycle is not getting stopped. Please find the attached image.

Please tell me what should do to create golden image, and what should be expected behavior.

over 7 years ago

0 answer over 7 years ago

TI__Intellectual 1735 points

click the golden image tab and then you can generate the image file.

0 Abhishek singh over 7 years ago in reply to answer

Expert 2000 points

Hi Chan,

I am thankful for you quick response. I have one doubt as per my understanding I have to perform learning cycle before creating golden image since I am performing learning cycle manually ie charging first then relax then discharge relax, do I have to do the whole process in one go with system connected with Bqstudio I am asking this because the whole process going to take more than 16-17 hours .

If have to do whole learning cycle continuously, is there is a way I can perform this in steps and able to create the golden image?

0 answer over 7 years ago in reply to Abhishek singh

TI__Intellectual 1735 points

Hi
You need to do a whole learning cycle to make sure the gauge is working well.
www.ti.com.cn/.../getliterature.tsp
You can follow the steps in the link to do it

Power management

Power management forum

BQ27441-G1: BQ27441-G1: Learning cycle in manual mode and Generating Golden image