Linux/BQ25703A: BQ25703 linux driver

The registers be set as below, is it right or not? I found charging function is wrong. Could you help to fix it?

(WDTWR_ADJ, 0);
(EN_LWPWR, 0);
(ADC_CONV, 1);
(ADC_START, 1);
(ADC_FULLSCALE, 1);
(EN_ADC_CMPIN, 1);
( EN_ADC_VBUS, 1);
(EN_ADC_PSYS, 1);
(EN_ADC_IIN, 1);
(EN_ADC_IDCHG, 1);
(EN_ADC_ICHG, 1);
(EN_ADC_VSYS, 1);
(EN_ADC_VBAT, 1);

We don't have Linux code for bq25703A. Please all ADC related registers don't affect charging function.
If you just want to enable the charge, please change the charge current setting register to a valid value. Also, what is the CELL-BATPRES pin voltage? Do you have an EVM to verify your code?

Thank you sir, we don't have EVM board for verifying.
=>Please all ADC related registers don't affect charging function.
What does this specifically mean? I do not need to use ADC related registers?

ADC doesn't set the charging parameter. They just monitor the channel you select.
To enable charge, please write a valid charge current to the charge current register.

Hi sir,

Is there code for MCU? or control timing code?

Right now, I don't see any code available from TI reference design. I am asking the reference design team to see if they can release any code.
BTW, so far, I don't see any Linux application.