Hi..
A have design board using BQ51050BRHLT base on datasheet.
Schematic as attached bellow.
That is run OK.
But how to I detect battery full when battery is full (if I not see dock change)?
Could Anyone give me advice to solve that problem.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi..
A have design board using BQ51050BRHLT base on datasheet.
Schematic as attached bellow.
That is run OK.
But how to I detect battery full when battery is full (if I not see dock change)?
Could Anyone give me advice to solve that problem.
Hi Bill Johns.
Thank you for your support.
I will test that design again and check CHG pin.
Best Regards.