TPS54218: Error while using Transient Model

Hoong Wei Chuah

Prodigy 60 points

Part Number: TPS54218

Hi,

While running transient simulation on TPS54218, keep facing error " Operating Point Not Found".

Need your help to check on our simulation file for whats going on?

Was playing with Analysis parameter but not able to solve still.

Thanks!

Regards,

Hoong Weislvm531.TSC

over 4 years ago

0 Tanvee over 4 years ago

TI__Genius 13460 points

Hi Hoong Wei,

Is the model is not working before you change the parameters or after changing the parameters?

Best regards,

Tanvee

0 Hoong Wei Chuah over 4 years ago in reply to Tanvee

Prodigy 60 points

Hi Tanvee,

Yes by default it works.

But after we modified it to our design then it stop working.

Thanks!

Regards,

Hoong Wei

0 Tanvee over 4 years ago in reply to Hoong Wei Chuah

TI__Genius 13460 points

Hi Hoong Wei,

Could you share the file where you are trying to capture the data? The attached file doesn't have any measurement point and I don't understand the purpose of R2 resistor (10 Ohm) in parallel to feedback divider that will drop the output voltage.

Best regards,

Tanvee

0 Tanvee over 4 years ago in reply to Tanvee

TI__Genius 13460 points

Hi Hoong Wei,

Did your issue is resolved? Please let me know if you still require help to solve it.

Best regards,

Tanvee

Power management

Power management forum

TPS54218: Error while using Transient Model