Other Parts Discussed in Thread: BUF16821,
Hi Sir,
We would like to use the output voltage of the novolatile memory has never been programmed.
Q1:
When we would like to use the output voltage of novolatile has never been programmed,
register setting of CODE10 is 200h only. Is it right?
Is there anything else that needs to be set?
Q2:
We set that register setting of CODE10 is 200h,
Its voltage outpur does not match the datasheet.
please teach us why.
[ DATA SHEET]
[Mesument data]
CH1 : output pin ( OUT9 ) no load, open.
CH2 : Vs
Our mesurement data has the low voltage period of about 300usec.
Please confirm this.
Best regards,
A.kimura