Part Number: TPS1H100-Q1
A customer of mine is looking for the leakage current of the status output pin of TPS1H100-Q1. Do we have this information?
Thanks for reaching out on E2E!
The leakage current of the status output pin is defined as Ileak,out in the datasheet, as shown below:
If my reply answered your question, please click the "This resolved my issue" button. This can help others verify that a solution was found!
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Elizabeth Higgins1:
Thank you for your response.
Just to confirm, the specs on the datasheet that you attached is not just for the OUT pin but is also for the ST pin. Is that correct?
In reply to Franz Figueroa32:
Apologies, I misunderstood your question. Since the ST pin is an open drain output and the leakage is very small, we do not specify it on the datasheet. However, it will be in the nanoampere range.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.