LP8860-Q1: LP8860-Q1 schematic review.

Dexter Choi

Expert 2795 points

Part Number: LP8860-Q1

Dear Sir,

Could you please review attached schematic.

please refer to the attached LED Spec.

SCHEMATIC1 _ 15.pdf

over 3 years ago

0 Charles-Chen over 3 years ago

TI__Genius 11836 points

Hi Dexter,

Please also add 0.1 uF capacitor at VDD pin. The output capacitor is a little bit small when considering the derating of ceramic capacitor. And we also recommend to add 1nF capacitor from OUTx to GND. Please also ensure you have the enough voltage margin of Q404 and D208. Pull up resistor is also needed for SCL and SDA when I2C communication is selected.

0 Dexter Choi over 3 years ago in reply to Charles-Chen

Expert 2795 points

Dear Charles,

Thank you for your support.

OUTx 1nF capacitor mean are OUT1,2,3,4 line? or 42V_LED-A line? as like below schematic.

0 Charles-Chen over 3 years ago in reply to Dexter Choi

TI__Genius 11836 points

Hi Dexter,

Please see the below figure.

Power management

Power management forum

LP8860-Q1: LP8860-Q1 schematic review.