Other Parts Discussed in Thread: BQ34Z100
Question from my customer, can you help with this?
For gas gauge programming we have been using a .srec file and using BQStudio to do the programming. Currently we do not enable the IT_ENABLE bit in the file but do it afterwards within the BQStudio software. We do this because some documents seem to indicate to do it that way.
My Subcon has written some gas gauge programming firmware but they are using a .bq.fs file.
I have a question about the IT_ENABLE bit. Should we keep that clear within the file and enable it after we program the file into the gas gauge or can we have it set within the file itself?