Hi,
I am using UCD90160 on my board. I configured the voltage rails and the enable pins. And the voltage are coming up fine. This is monitored using the GUI and the USB interface adapter.
But once the storing RAM to flash is done, and the USB interface adapter is disconnected from the board and then when the board is powered on, the voltage are not coming up, which are probed using a multimeter.
Please help.
Regards,
Rasif
The xml file is attached herewith.Partial Board_3V3_aCTIVE HIGH OPEN DRAIN_SEQUENCED.xml
The schematics is as attached below: