J7200XSOMXEVM: XDS110 USB cable not working

Jizhou Zhang said:

I am able to plug-in the USB cable to XDS110 port on J7200 EVM board, and the debugger seems work fine.

So here what is the host PC? Ubuntu? How did you determine that debugger is working fine?

Jizhou Zhang said:

Then I connect the the cable to my desktop, and the XDS cannot be recognized.

Then above how did you verify debugger working?

Jizhou Zhang said:

When I run "lsusb", the TI debugger is showed up but when I ran "xdsdfu -e", it shows "Found 0 devices". Could you give me some advice regarding ?

Do you want to connect to CCS & debug? What is your objective?

- Keerthy

Hey Keerthy,

Keerthy J said:

I am able to plug-in the USB cable to XDS110 port on J7200 EVM board, and the debugger seems work fine.

This one runs on my laptop, my laptop is ubuntu18.04. I am able to launch debug session via CCS

Keerthy J said:

Then I connect the the cable to my desktop, and the XDS cannot be recognized.

I plug the USB cable to my desktop, and the CCS debug session cannot start.

Keerthy J said:

Do you want to connect to CCS & debug? What is your objective?

Yes, try to use CCS to load and debug program via XDS110.

Jizhou Zhang said:

I plug the USB cable to my desktop, and the CCS debug session cannot start.

That is windows? I am able to run CCS on my windows 10 laptop. If it is ubuntu desktop please try to get the same working 18.04 working version.

Let me know which OS is on your desktop.

Best Regards,
Keerthy

Both Laptop and Desktop are using Ubuntu18.04