Other Parts Discussed in Thread: DRA821, CSD
Hi team,
The following issues were observed during patches after EMMC burning:
1) The bin file with uboot cannot be started when finished burning. While the bin file can be started when importing mmcblk0boot0 with dd command.
2) "MMC partconf 0 1 1 1 1 1;MMC bootbus 0 2 0" entering uboot using SD boot mode, this command enables the unbootable hardware to boot.
"MMC partconf 0 1 1 1 1; MMC bootbus 0 2 0 0"
The customer would like to know if this command read or write to some EEPROM registers of DRA821 or EMMC. Could you help check this case? Thanks.
Best Regards,
Cherry