AM62D-Q1: Commonality between AM62A and Am62D w.r.t. McASP1

Venkata Someswararao Malla

Part Number: AM62D-Q1

Hi Team,

I am working on AM62A EVK and building the fitimage using am62a linux SDK, and configured it to interface with STA710(McASP1, I2S for I/Q and SPI) , can the same SW be used on AM62D for same interface.

What changes I need to consider if I want to test the same interface on AM62D.

Regards,

Venkata

3 months ago

0 Suren Porwar 3 months ago

TI__Mastermind 34110 points

Hi Venkata,

If you're HLOS is Linux, then it should be similar. Please make sure, the pinmux controls are properly configured in the device tree (Based on TRM/Datasheet).

Best Regards,

Suren

0 Venkata Someswararao Malla 3 months ago in reply to Suren Porwar

Prodigy 121 points

thanks Suren. Yes we are using Linux.

0 Suren Porwar 3 months ago in reply to Venkata Someswararao Malla

TI__Mastermind 34110 points

Hi Venkata,

Since I have already answered based on Linux as the HLOS, I assume, I will go ahead and close this thread. Feel free to open newer thread for any further support.

Best Regards,

Suren

Processors

Processors forum

AM62D-Q1: Commonality between AM62A and Am62D w.r.t. McASP1