• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 101 subscribers
  • Views 190 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Blunder recovery.

Umar Khan
Intellectual 320 points
Other Parts Discussed in Thread: ADS8556, ADS8361EVM, DAC8831EVM

Hi,

       I planned to plug in an ADS8556 EVM    AND  a DAC7741EVM     TOGETHER  onto a 5-6K interface board, which was to be connected to a C6713 DSK. Since both the EVMs are parallel  they did NOT fit on the 5-6K TOGETHER , but sadly I found this out only after unpacking the boxes :(

Now, I have selected again two serial SPI EVMs, the  ADS8361EVM  and DAC8831EVM. I want to put them  TOGETHER on a 5-6K interface board. I will also plug in at the same time two DAP Signal conditioning boards one unipolar and one bipolar.

I have checked, googled asked around and THINK all these four will fit TOGETHER on a 5-6K board.  If I am wrong can any one PLEASE tell me so before I order again.

Any response will be HIGHLY appreciated!!! 

  • 0
    Expert 2210 points

    I don't have those particular EVMs, but generally speaking if the serial EVMs are of a physical size such that two of them can fit on the 5-6K interface, then it is okay to use them both at the same time, each with its own DAP (unipolar or bipolar, depending on the EVM).  If you examine the 5-6K schematic you will see that they use independent channels.  Note that a DAP for a D/A EVM will be mounted upside-down from how a DAP is mounted for an A/D EVM.