AM3358-EP: CPSW FIFO management

Mark Fletcher

Part Number: AM3358-EP

Hi there,

I have a mature bare-metal application using the AM3358-EP and its Ethernet subsystem (SPRUH73Q TRM chapter 14).

I have some questions relating to the 3x CPSW_3G port RX FIFOs (1x host FIFO Port 0, and the 2x external FIFOs Ports 1 & 2).

At an arbitrary point in time with the Ethernet Subsystem sending and receiving typical Ethernet frames...

1) how can I ensure that new data is not passed into the 3x CPSW_3G port RX FIFOs?

2) how can I flush any existing data in the 3x CPSW_3G port RX FIFOs?

I'd like to change only what's necessary, accounting for any side-effects.

I understand a channel teardown will only prevent the DMA reading from the host FIFO to place into Buffer Descriptors.

I find Chapter 14.3.2.18 Software Reset ambiguous, where many terms do not align with register addresses/descriptions.

With thanks, Mark

over 5 years ago

0 Schuyler Patton over 5 years ago

TI__Mastermind 38980 points

Hi,

We are checking into the questions you asked.

One to prevent new data from the RX FIFOs on the external CPSW ports is by setting in the CPSW_ALE REGISTERS section these registers PORTCTL1 and PORTCTL2 to blocked. These are bits 1-0 need to be set to a 1.

Concerning the flushing of the RX FIFO is what we are checking into.

Best Regards,

Schuyler

0 Mark Fletcher over 5 years ago in reply to Schuyler Patton

Intellectual 260 points

Good morning Schuyler,

Thank you for your response - I've been able to use the CPSW_ALE CONTROL register ENABLE_ALE bit to prevent new data entering the FIFOs.

This, along with a reconfiguration of ALE registers (later), also appears to 'flush' the FIFOs.

Many thanks, Mark

Processors

Processors forum

AM3358-EP: CPSW FIFO management