As far as i know, internall busholders/pulls must prevent the port from power dissipation or in worst cases - burnouts, due to undefined input state of CMOS input logic.
I pull GPIO6 low, so multiplexed pins go in PGPIO mode.
Then I try to configure XBCR and I see, that busholders/pulls take no effect. Even if busholders/pulls are disabled, theres no floating signal on input pins. (i poll them and get constant value for over a long time even with busholders disabled).
Please, can anyone share some best practics or their own expierience on setting up busholders/pulls?