Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: UHS-I SDR104 Receive mode timing

    Part Number: AM625 Tool/software: Hi, Datasheet section 7.11.5.16.2.7 only provides Transmit Mode timings. My customer is asking for receive mode timings. Thanks and regards, Koichiro Tashiro

  • [FAQ] TDA4VM-Q1: TIDL back port guide including SDK 9.x and SDK 10.x

    Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM Tool/software: New features of TIDL are always added with new SDK release, but it is not possible to upgrade the whole SDK because this will affect all parts of software. This thread will…

  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Design Recommendations / Custom board hardware design – common queries for PMIC TPS65224-Q1

    Part Number: AM62P Other Parts Discussed in Thread: TPS65224-Q1 , TPS65219 , , TPS65224 , AM62A7 , AM62A3 , AM62A7-Q1 , AM62A3-Q1 , USB2ANY , AM6442 , TPS22918 Tool/software: HI Board designers, I am designing my board using TPS65224-Q1 PMIC Are…

  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Design Recommendations / Custom board hardware design – common queries for PMIC TPS6593

    Part Number: AM62A74 Other Parts Discussed in Thread: TPS6594-Q1 , TPS65224 , AM62A7-Q1 , TPS6593-Q1 , TPS22918 Tool/software: HI Board designers, I am designing my board using TPS6593 PMIC Are there some common recommendation or observations…

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Design Recommendations / Custom board hardware design – Common queries for PMIC TPS65219 and PDN

    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6521905 , TPS65215 , AM2434 , TPS65220 , AM6421 , TPS22918 , , TPS6522005-EP Tool/software: HI Board designers, I am designing my board using TPS65219. Are there some common recommendation…

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: Custom board hardware design – Connection recommendations for RSVD pins

    Part Number: AM625 Tool/software: Hi TI Experts, I see some of the processor pins named RSVD. Are there some recommendations to be followed during custom board design.

  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Custom board hardware design – Queries regarding crystal (MCU_OSC0) Start-up Time

    Part Number: AM625 Other Parts Discussed in Thread: AM6442 , , AM62P , SYSCONFIG Tool/software: Hi TI Experts, I have a question about "Figure 7-16. MCU_OSC0 Start-up Time" from the datasheet. Here it looks like that MCU_OSC0 is only allowed to…

  • [FAQ] AM3357: ADC AIN input for AM3357 (also applies to AM3352 , AM3354 , AM3356 ,AM3358 , AM3359)

    Part Number: AM3357 Tool/software: Hi team, I am planning to input an analog signal to AM3357's AIN by dividing the voltage. Was the constant of the voltage divider resistor OK with the constant shown in the figure? I am wondering if I should add…

  • [FAQ] AM62x, AM62Ax, AM62Px, AM62D-Q1, AM64x, AM243x: OSPI Phy Tuning Algorithm

    Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Questions addressed in this post: What is OSPI Phy Tuning? When is the Phy Tuning Algorithm used? Where is the Phy enabled and disabled throughout the MCU PLUS SDK…

  • [FAQ] AM6442: Clock Specifications for SERDES0_REFCLK0N SERDES0_REFCLK0P and USB3

    Part Number: AM6442 Other Parts Discussed in Thread: SK-AM64B Tool/software: Hello, I am designing a board with Ethernet and USB3 using the AM6442. I have referred to the device sheet and TRM, but I could not find the required specifications for…

View FAQ threads
  • Threads 199059 Discussions