cc3200 launchpad integration with HDC1000YPAT

Hector Otero

Other Parts Discussed in Thread: HDC1000, CC2650, CC3200

Hi,

My question is how do integrate the HDC1000YPAT humidity sensor with the launchpad? Does it require soldering or some other technique? Where on the board does the sensor go? Please provide relevant resources. Thank you.

Best regards,
Hector O.

over 10 years ago

0 Massimo Mascotto over 10 years ago

TI__Intellectual 1960 points

Dear Hector

There is an reference design just release that integrate the HDC1000 with the CC2650 (TIDA-00374--> www.ti.com/.../TIDA-00374)

The HDC1000EVM cannot be connected directly with the Launchpad, but is possible to separate the tip of the EVM and wired the 4 signal to the Launchpad (VDD, GND, SDA, SCL)

Another TI reference Design based on CC3200 is under development.

Best Regards
Massimo

Sensors

Sensors forum

cc3200 launchpad integration with HDC1000YPAT