This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: LMX8410L
My customer has the following questions about lmx8410, and I am not familiar with RF. Please help me. Thank you in advance.
Use two lmx8410 evaluation boards.
SYNC is 10MHz discontinuous pulse signal（what is the format of sync signal?）
The OSCin, RFin ,and SYNC are synchronous, and the SYNC pulse signal is triggered manually outside, and the phase synchronization cannot be carried out. What are the specific software and hardware implementation steps to achieve the phase synchronization?
Note: both OSCin and SYNC are synchronization signals provided by external HMC7044.
Best Regards, Amy Luo
The SYNC pin is an input pin. A square pulse, with a strong slew rate / rising edge would be recommended. Please ensure you meet voltage levels mentioned in the datasheet under "DIGITAL INTERFACE (SCK, SDI, CSB, MUXOUT, SYNC, CE)" section of "Electrical Characteristics".
For cases where the LO output frequency is not a multiple of the input frequency, such as yours the SYNC pin must be used and the timing must be away from the rising edge of the OSCin signal. You will also need to ensure that the SYNC timing meets the setup and hold time for the SYNC pin listed in "6.6 Timing Requirements" section.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Vibhu Vanjari:
Thank you very much.
Now, the two signals can be synchronized occasionally, but many times after the SYNC pulse is sent, the phase difference is very large. Referring to your suggestions, the customer has made the following analysis:
As shown in the figure, the distance between the rising edge of SYNC and the rising edge of OSCin is at least 3 ns, which should be satisfied.
Secondly, the duration of high level reaches us level, which should also satisfy tHOLD.
About tSETUP you mentioned, I can't understand it. Can you explain it in detail?
2. The waveform of SYNC signal is shown in the following figure:
The red waveform is OSCin, and the blue is SYNC pulse. Observing the SYNC signal, we can see that there is a burr of about 950mv in front of and behind of the pulse signal. Does this make LMX8410 mistakenly identify as SYNC pulse and produce wrong synchronization?
In reply to Amy Luo:
The setup time is the time SYNC must be high before OSCin goes high. I would not think the blip is causing the issue, however would you be able to try using a difference SYNC source to narrow down the issue.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.