Why SmartRF Studio console indicates that "Buffer overflow" when rx receives packets?

Sean Auyeung

Expert 1025 points

Hi engineers,

My problem is shown in the picture as below. Is there any setting I can configure?

Best Regards,

Sean

0 Sean Auyeung over 3 years ago

Expert 1025 points

My configuration is shown as below.

0 Sean Auyeung over 3 years ago in reply to Sean Auyeung

Expert 1025 points

I've set RX side parameter "Length Config" as "Fixed" to 255 bytes.

0 Elin W over 3 years ago

Hi Sean,

Assigning an expert to comment.

Thanks,
Elin

0 Sean Auyeung over 3 years ago in reply to Elin W

Expert 1025 points

Hi Elin,

Thanks for your response, I'm happy to hear your good news!

Best Regards,

Sean

0 Sean Auyeung over 3 years ago in reply to Sean Auyeung

Expert 1025 points

I've found the solution on the menu bar "HELP" -> "Device Control Panel", it's shown in the below.

RF & microwave forum