Help! Uniflash can't open the port!

user5136145

Other Parts Discussed in Thread: UNIFLASH, AWR1642

When using Uniflash connecting AWR1642 Evm, How to solve the problem--not able to connect serial port? Problem description like the picture below shows(jumpers have already been set into 101 mode ):

over 7 years ago

0 Cesar over 7 years ago

TI__Guru**** 151514 points

Hi,

Is this the first time you are trying to flash on this board?

Please make sure you are using correct COM port, SOP settings, power supply

thank you
Cesar

0 user5136145 over 7 years ago in reply to Cesar

Prodigy 20 points

yes, that's the first time we try, COM port and SOP settings had been already set correct.

thank you
lihe

0 Chris Meng over 7 years ago in reply to user5136145

TI__Mastermind 39146 points

Lihe,

Have you see below two com ports in PC device manager when you connected the EVM to PC?
XDS110 Class Application/User UART (COM UART):Used for passing configuration data and firmware to the EVM
XDS110 Class Auxiliary Data Port (COM AUX): Used to send processed radar data output

Have you set the right COM port number in Uniflash (COM UART)?

Sensors

Sensors forum

Help! Uniflash can't open the port!