AWR1243BOOST: In Radar Studio while configuring in functional mode RF power-up is failing.

Patrick Pross

Part Number: AWR1243BOOST

I have the same Problem but in Mode2 (Development). After I pushed the button RF Power-Up I'll get "Status: Failed, Error Type: RESP TIMEOUT

over 5 years ago

0 Cesar over 5 years ago

TI__Guru*** 138339 points

Which version of Radar Studio are you using?

thank you
Cesar

0 Randy Rosales over 5 years ago in reply to Cesar

TI__Genius 17200 points

Hi Patrick,

Can you also please confirm your full hardware setup? Has this ever worked for you? You need the AWR1243BOOST and Development Package to run the device in development mode with Radar Studio.

Thanks,
Randy

0 Patrick Pross over 5 years ago in reply to Cesar

Prodigy 155 points

I'm using Radar Studio v1.9.2.1

0 Patrick Pross over 5 years ago in reply to Randy Rosales

Prodigy 155 points

Yes it has worked once, but at next day it didn't work anymore

0 Randy Rosales over 5 years ago in reply to Patrick Pross

TI__Genius 17200 points

Hi Patrick,

Sorry to repeat my question, but can you also please confirm your full hardware setup?

Thank you,
Randy

0 Patrick Pross over 5 years ago in reply to Randy Rosales

Prodigy 155 points

Hi
Yes everything about hardware should be fine.

0 Randy Rosales over 5 years ago in reply to Patrick Pross

TI__Genius 17200 points

Hi Patrick,

Please accept my E2E friend request so we can discuss further options.

Thank you,
Randy

0 Randy Rosales over 5 years ago in reply to Randy Rosales

TI__Genius 17200 points

Hi Patrick,

I have not seen a response to this topic in a few weeks now. I am going to go ahead and suggest this post be closed. If your problem has not been resolved please open up a new post on this topic.

Thank you,
Randy

Sensors

Sensors forum

AWR1243BOOST: In Radar Studio while configuring in functional mode RF power-up is failing.