OPT3001EVM: OPT3001EVM: OPT3001EVM always shows same value on EVM GUI

Hi Alex,

here some screenshots:

still no change in the graph when I'm putting sth over the sensor.

Best regards,

Marion

somehow they are not displayed:

Hi Marion,

I see the run continuously switch is down. Are you getting values by manually clicking "read reg x00"? If you could tell me exactly what you do from starting the GUI to getting the 83klux values? Also if you could also attach a pic of the actual EVM board I can check it for errors.

Best,

Alex

Hi Alex,

I switched it off to do a picture. I do get also the same data when I click manually on the read Reg x00 button: 83865.6 Lux.

But I see no changes, when I dim the light or put sth over the sensor, so I can not modify the data.

I connect the EVM to the Laptop and open the GUI. I tried it the other way around as well. I did not change anything else.

Can we maybe set up a call to accelerate the process? Please write me privately and offer a time slot.

Best regards,

Marion Loessl 

Hi Alex,

I really need some help here.

I reproduced the setup and I continue to have 83865.6 Lux, no matter what  I do with the sensor.

Best regards,

Marion