AWR1843BOOST: Resource Explorer Ready-Codes Selection

Lacin Tuncer

Part Number: AWR1843BOOST
Other Parts Discussed in Thread: AWR1843

Hi there,

I have a project that is including AWR1842BOOST evaluation boards and the aim is measure distances and speeds vehicles around our vehicle. Our vehicle can move. We will control our vehicle with Jetson Nano. And we want to communicate between AWR1842BOOST evaluation board and Jetson Nano.

I need to ready-codes which is CCS has. We want to measure up to 100m distance. And we need to get speeds vehicles around us.

Could you suggest any ready-code?

Resource Explorer/ Software / mmWave Sensors / Automotive toolbox - 3.4.0 / Labs / ???????

over 3 years ago

0 Jitendra Gupta over 3 years ago

TI__Guru 69960 points

Hi,

For AWR1843, there are multiple application available on TI-Rex

https://dev.ti.com/tirex/explore/node?node=AObIl5yAPR-DjIwxgdgyuA__AocYeEd__LATEST

https://dev.ti.com/tirex/explore/node?node=AJz0Sish0qIA72e7InIbEw__AocYeEd__LATEST

These project has the CCS project and the all the source code which you can edit and compile with mmwave SDK.

Video for MRR

https://www.youtube.com/watch?v=1PkcbE3zrYo

Regards,

Jitendra

0 Lacin Tuncer over 3 years ago in reply to Jitendra Gupta

Intellectual 630 points

Hello Jitendra,

I looked at these examples but couldn't decide between the two. What is the difference between them?

0 Jitendra Gupta over 3 years ago in reply to Lacin Tuncer

TI__Guru 69960 points

MRR application uses basic frame configuration

whereas MRR Beam forming uses Phase Shift APIs to form a beam (high energy on a focused point) and then it steer the same beam from one angle to other angle in the given scene.

You can use MRR beam forming to get better range performance

Now, these two demos uses UART interface which you can connect with your external processor to read the object data and take decision.

Regards,

Jitendra

Sensors

Sensors forum

AWR1843BOOST: Resource Explorer Ready-Codes Selection