Dear Team,
Sometimes I become incorrect data by reading the Temperature result register.
In my process, I start a conversion and wait 100ms before reading the result register.
I'm using one-shot conversion.
But sometimes the value I read is incorrect.
I have the same symptoms of this discussion I found in the forum : https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/995346/tmp-117-read-incorrect-data-occasionally/3701141?tisearch=e2e-sitesearch&keymatch=TMP117#3701141
But I didn't understand what was the key.
I analyse the I2C line with a scope and I read the same value that I see on the bus.
Do you have any suggestion of what I have to check?
The communication speed is arround 300kHz.
Best regards and thanks for your help!
Lionel