IWR6843ISK: May I ask where I can find the Lab code and visualizer for the people counting?

Hello

We make the content/collateral accessible in various ways.

Considering you have looked at two resources listed lets start with those:

Yong Yuan said:

www.ti.com/.../quote]

Under above TI-Design Page:

People Tracking and Counting Reference Design Using mmWave Radar Sensor (Rev. x)  -->  Mentions TI Resource Explorer on front page

We will edit this to include the Landing Page of Industrial Toolbox to make it robust against future changes

--> Labs/ <Various Demos>

Note: List of demos may change. Above is based on Industrial Toolbox (4.9.0)

Yong Yuan said:

www.youtube.com/watch

Description page provides path to Product Family pages which can take you to various applications including the people counting - building automation

Industrial (IWR) mmWave radar sensors  --> Applications  --> Building automation 

Here you will find various resources to recreate People Counting application run including SW, HW, setup and results.

Regarding the 2D version of the lab:

Tirex People Counting (4.9.x)  landing page has a table that shows features specific to labs. Please see the 2D version there.

Hope this helps you get started.

Thank you,

Vaibhav

[/quote]

Thank you very much! I also noticed the lab for  "68xx ISK - Sense and Direct HVAC Control" and thought it should be the 2D version I am looking for. I also tried the instructions to write the corresponding image to the device flash. Then, I also ran the same people counting GUI and switched to "Sense and Detect HVAC control" or the "legacy 2D people counting". However, it still shew me the 3D people counting output. How should I configure the GUI to show the 2D version? Thanks!

Hello,

Sorry for the delay, we were on national holiday.  That 2D GUI has been replaced by this 3D GUI. The data coming from the device is still in 2D, it just gets plotted in a 3D graph. Is there something specific you wish to see from that GUI? The old 2D GUI should be available in a previous version of the toolbox. Try version 4.0.0 of the toolbox.

Regards,

Jackson

Got it, thanks! may I ask where can I find 4.0.0? Just want to further develop on the 2D GUI for some demo.