Hey,
We have been using the DRV5023 hall effect sensors continuously for different projects,
So far we were mounting the sensors to the pcb & align manual w.r.t to motor wave form.
For the new project we wanted to place the sensors into the stator slots, We have calculated
the slot positions for 120 edeg, 60 edeg & 30 edeg. We wanted your support to cross check
for the arrived slot positions along with set of guide lines & calculation support from your end.
Kindly do the needful earliest.
Thanks & Regards,
Akil Kumar H
+91-7846021264
R&D-Nimble Electric
A division of UCAM PVT.LTD.
A-11/12,1st stage 1st cross
Peenya Industrial Area
Bengaluru- 560058
Karnataka,India.
www.nimbleelectric.com
www.ucamind.com
