AWR1843AOP: Antenna absolute coordinates in relation to ball A1

MCV

Part Number: AWR1843AOP

Guys,

Customer is looking for the antennas coordinates in absolute terms (related to ball A1) and not in relative terms like given in the datasheet (SWRS236A §7.10.2.)

Thx,

MCV

over 2 years ago

0 aozer over 2 years ago

TI__Mastermind 26915 points

Hello,

I have asked our designer for the dimensions. I will let you know what she says.

Regards,

Adrian

0 Hong Liu over 2 years ago

Prodigy 30 points

Hello Adrian,

Thank you for your hellp. When can you provide the antennas coordinates?

Best wishes,

Chris

+1 aozer over 2 years ago in reply to Hong Liu

TI__Mastermind 26915 points

Hello,

Below is the distance from the edge of the package to the center of RX4 and TX3. From here you can derive the distance for the other antennas based on the antenna spacing. Is this sufficient for your needs?

Regards,

Adrian

0 Hong Liu over 2 years ago in reply to aozer

Prodigy 30 points

Hello Adrian,

Thank you very much! But that is not what I need. What you provide is the relative position between the antennas. What I need is the form and size of the antenna, as shown in the figure below.

Best wishes,

Chris

0 aozer over 2 years ago in reply to Hong Liu

TI__Mastermind 26915 points

Hello Chris,

Sorry for the delay. The size of each patch on the AWR1843AoP is .71mm x 1.2mm, does this answer your questions?

Regards,

Adrian

Sensors

Sensors forum

AWR1843AOP: Antenna absolute coordinates in relation to ball A1