Because of the Thanksgiving holiday in the U.S., TI E2E design support forum responses may be delayed the week of Nov. 21. Thank you for your patience.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TDC7200: TDC7200 Register 00 is written to 03, and TRI has no signal output

Part Number: TDC7200
Other Parts Discussed in Thread: TDC1000

HI TEAMS:

TDC7200 enable has also tried to use IO control to pull up the enable after 3.3V power supply.

The current process is:

Chip power on - initialize SPI - enable pull up - write register

At present, register reading and writing are as follows:

After 0x03 is written in 0x00 register of 7200, it is not reset to 0 as specified in the specification

The schematic diagram is as follows: tdc7200

TDC1000

  • Hello Kevin,

    It looks like your system is reading the registers correctly. Wiriting 0x03 to register CONFIG1 (0x00) will only clear the INT_STATUS register (0x02) as well as the result registers TIME1 to TIME6, CLOCK_COUNT1 to CLOCK_COUNT5, CALIBRATION1, CALIBRATION2 (registers 0x10 to 0x1C). Can you provide more information on what registers are not being reset to 0 as mentioned in the specification?

    Best,

    Isaac