Other Parts Discussed in Thread: AWR1843BOOST, DCA1000EVM
Hi,
I have a question on how to collect raw ADC data with beam steering configuration.
I have read the MRR Beam Steering lab from here. On page 5, it has configuration as below.
The radar was configured to scan from -60 degrees to 60 degrees with step size of 20 degrees. In this case, the beam steering cycle is 7, namely [-60deg, -40deg, -20deg, 0deg, 20deg, 40deg, 60deg]
From this post, I understand that all TXs were triggered simultaneously.
In my case, I use IWR1642Boost, two TXs of IWR1642Boost should be configured with different phase shift values for [-60deg, -40deg, -20deg, 0deg, 20deg, 40deg, 60deg], respectively.
Is there reference I can refer for such configurations?
For example, how to configure these two TXs with beam steering at - 60deg on mmwave studio?
Thanks a lot for the hints!
Best,
Hang