IWR6843AOP: Pins needed to use MMWAVEICBOOST to debug IWR6843AOP

Hi!

Thanks for looking into my question.

I am trying to design a circuit board for IWR6843AOP. I wish to retain the CCS debug capability. Thus I try to the the signals needed for debug and connect only them to the 60 pin high density connector on my board. I found that only RS232TX, RS232RX, TCK, TMS, TDO, TDI, MSS_LOGGER, BSS_LOGGER, I2C_SDA and I2C_SCL is connected to XDS110 on the MMWAVEICBOOST:

I wondering whether this signals plus the power and ground are enough to enable the CCS debug mode?

Thanks!