Other Parts Discussed in Thread: MMWAVEICBOOST, DCA1000EVM
Hi, TI team,
Q1. I'm using mmWave Studio tool to capture ADC RAW data for our software simulation. All my HW setup (AWR6843AoPEVM + MMWAVEICBOOST + DCA1000 boards) and the corresponding capturing data configurations follow the steps in "Raw Data Capture for XWR6843 Device Using DCA1000 Board and mmWave Studio".
But I find the captured RAW data size always have only 1/3 size as I expect. I guess the mmWave Studio only record one of the TX data. Following figures show my configurations, would you please tell me does something goes wrong?
Q2. I want to know that if possible to capture ADC RAW data using same HW configuration but shift to use mmWave-Demo Visualizer tool?
Looking forward for your guidance.
Regards,
Shihyu