• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 31 subscribers
  • Views 157 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMCS1100: tmcs1100

swetcha tempalle
Prodigy 20 points
Part Number: TMCS1100

How do the typical equipment set up and connections look like for plotting sensitivity vs frequency (fig 7-9) and phase vs frequency (fig 7-10)?  I am interested to know how much curent value was used compared to the max rating of 30A for this IC?

  • 0
    TI__Mastermind 18780 points

    swetcha,

    I am looking into this, but the engineer who supported these tests is out for the day. I will check in with him and will provide an update on Monday.

  • 0 in reply to Carolus Andrews
    TI__Mastermind 18780 points

    swetcha,

    Sorry for the delay here. This data took a while to run down. 

    The engineer's main intent was to have a small signal on the output, as to not slew rate limit the results. They used a 200mV output, so the input signal is that value modified by the sensitivity. So for example, for the A1, 50mV/Amp = 4 Amps, and for the A4, 400mV/Amp= 0.5 Amps.  

    The data for both this capture as well as the phase capture was performed using a BODE100. 

    Please let me know if you have further questions.