IWR6843ISK: Configure Single-point frequency continuous mode in the mmWave_Demo_Visualizer using the IWR6843ISK board

Hello.

Sorry for the late response.  There is no way built in to the SDK/visualizer to configure single point frequency continuous mode for the ISK.  However, you can stream data in continuous mode using the DCA 1000 data capture card/mmwave studio.  In addition, you can add code to the mmwave link layer to enable continuous mode.  I have included links to e2es that address both.

Sincerely,

Santosh

Link to using DCA for CW mode E2E: https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/889292/dca1000evm-how-to-use-cw-mode-using-dca1000evm-at-mmwave-studio

Link to using mmwave link layer api: https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/952410/iwr6843isk-continuous-transmit-mode-single-frequency