TMP421: DXP and DXN not used connections

Barry Robinson

Part Number: TMP421
Other Parts Discussed in Thread: DXP

For the TMP421, the data sheet states "If the remote channel is not utilized, DXP can be left open or tied to GND." However, nothing is stated about the DXN pin. How shall I connect the DXN pin? My application will not used the external sensor option.

over 1 year ago

0 Josh Wyatt over 1 year ago

TI__Guru* 91146 points

Dear Barry -

The DXN pin in this device is GND. On page 23 of the TMP42x datasheet, on page 23 "Sensor Fault" section - there is direct instruction (for the TMP421) to connect DXP to DXN together when not using the remote channel, to prevent meaningless fault warnings.

0 Barry Robinson over 1 year ago

Prodigy 30 points

Thanks for the quick reply and obviously I didn't get far enough down into the data sheet.

0 Josh Wyatt over 1 year ago in reply to Barry Robinson

TI__Guru* 91146 points

Great! Glad to help!

Sensors

Sensors forum

TMP421: DXP and DXN not used connections