DRV5013-Q1: Hall Element Position Tolerance

Yuya Shoji

Expert 4520 points

Part Number: DRV5013-Q1
Other Parts Discussed in Thread: DRV5015-Q1, DRV5023

Hi team,

Could you tell me this Hall element position and its tolerance for the simulation?

I need the values as below image shows at least.

I need this package height as well.

Does DRV5015-Q1 have the same Hall element from the perspective of position and its tolerance?

Best Regards,

Shoji

over 1 year ago

0 Patrick Simmons over 1 year ago

TI__Mastermind 25545 points

Hello Shoji,

I need to check with my team on this, however I suspect tolerances of +-1.5mm and +-1mm are a bit pessimistic presuming an array of devices where placed at exactly the same spot on a pcb.

+1 Patrick Simmons over 1 year ago in reply to Patrick Simmons

TI__Mastermind 25545 points

Hello Shoji,

I was told that the placement is similar to our DRV5023. Therefore, you should expect the sensing element to be in the center of the package in the xy plane with +-100um tolerance and 0.7mm +-50um from the bottom of the package. Also, in case you are not aware, we have our own simulation tool here: https://webench.ti.com/timss/

0 Yuya Shoji over 1 year ago in reply to Patrick Simmons

TI__Expert 4520 points

Hi Patrick,

Understood. Thank you for your support. Let me know if the position is actually different from DRV5023.

Best Regards,

Shoji

Sensors

Sensors forum

DRV5013-Q1: Hall Element Position Tolerance