This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TMCS1123: Non-Linearity Error

Part Number: TMCS1123

Hi team,

I try to recommend this device in PDU project, could you help check the questions below:

One question is about Non-Linearity Error.

 

My understanding is that if Non-Linearity Error is ±0.1% and I do a single point calibration, does that mean that the output of the HALL IC achieves 0.1% accuracy under OUT Voltage Linear Range?

Thanks

Lillian

  • Hi Lillian,

    Thank you for your post. 

    We actually recommend two point calibration to remove offset and gain error. This should be done with every other condition at your normal operating conditions. 

    Then the non-linearity error assessment should be used. Does this make sense?

    Best Regards,

    Joe