This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

IWR1443BOOST: Unable to separate individual Tx data from IWR1443BOOST using DCA1000EVM in TDM and BPM modes.

Part Number: IWR1443BOOST
Other Parts Discussed in Thread: DCA1000EVM

I am trying to capture IQ raw data from IWR1443BOOST with DCA1000EVM. I am using MMWAVE STUDIO for the data capture in all three Tx enabled configuration, but unable to separate individual Tx data while exporting.  

I have following queries


  • How to set the Tx configuration in TDM(Time Division Multiplexing) mode.
  • How to separate out the Received data for individual Tx.


  • How to set the Tx configuration in BPM(Binary Phase Modulated) mode, with all 3 Tx enabled.
  • Since IWR series boards can transmit simultaneously 2Tx at a time, what will be the sequence of switching of TX, when all 3 Tx are enabled for transmission.
  • How to separate out the Received data, for transmission.

I could not find any solution with the available TI documentation. If any sample code is there please share.

Please help me in this regard.