Tool/software:
Dear Technical Support Team,
Is it possible to automatically save the temperature data that has been converted in "continuous conversion mode" to EEPROM each time, and read the stored data at once from EEPROM after A mode is turned off?
Best Regards,
ttd
Hi Ren,
Thank you for your reply.
>The TMP1826 does hold the most recent temperature reading in volatile memory. It can be read from the scratchpad at any time.
VDD power and Set CONV_MODE_SEL(Conversion Interval), "continuous conversion mode" start immediately?
I'd like to know the Sequence like "Table 9-6. Single Device Temperature Conversion and Read Scratchpad-1 "
Is it ok to execute yellow(read temp data sequence) until next conversion?
Best Regards,
ttd
The fifth row in your image states that you must wait tCONV, which is the time it takes to make the temperature measurement. The tCONV depends on the CONV_TIME_SEL setting.
thanks,
ren
