TMP100: Read data from the temperature sensor

SRIDHAR P

Part Number: TMP100

Tool/software:

Hello TI,

We are currently working in TMP100NA/3K temperature sensor. If you have any driver code for this sensor to initialize the I2c communication?.. and also provide the data calibration code for reference.

over 1 year ago

0 HarryG over 1 year ago

TI__Expert 7070 points

Hello Sridhar,

Below is the link to the page for the drivers. Please note that this driver was created by the linux community. TI does not contribute to, or have any control over, the linux kernel driver.

Drivers: https://www.ti.com/tool/LM75SW-LINUX

As for calibration, these devices are calibrated from factory and do not need additional calibration beyond that.

Regards,

Harry Gill

0 SRIDHAR P over 1 year ago in reply to HarryG

Prodigy 70 points

Hi Harry,

The above given driver code doesn't have a main function. Can you please provide the Main function (or) Where is it placed in the device tree.

Regards,

SRIDHAR P

0 SRIDHAR P over 1 year ago in reply to HarryG

Prodigy 70 points

Hi Harry,

And also, we use this TMP100NA/3K in Arm625, the TMP100NA/3K is connected to the I2c2 of the Soc. Can you please provide me the example of device tree definition for initializing the TMP100NA/3K in AM62.

0 HarryG over 1 year ago in reply to SRIDHAR P

TI__Expert 7070 points

Hello Sridhar,

Please see the attached link for documentation and an example (it is also applicable to the TMP100):

https://github.com/torvalds/linux/blob/master/Documentation/devicetree/bindings/hwmon/lm75.yaml

As a friendly reminder, this was created by the linux community. TI does not contribute to, or have any control over this content..

Additionally if you require additional support for the AM62, I would highly encourage you to reach out to that team for assistance on hardware implementation.

Hope this helps,

Harry Gill

0 SRIDHAR P over 1 year ago in reply to HarryG

Prodigy 70 points

Hi Harry,

Here i declared the i2c2 device tree definition for TMP100 in linux kernal,

&main_i2c2 {
	status = "okay";
	pinctrl-names = "default";
	pinctrl-0 = <&main_i2c2_pins_default>;
	clock-frequency = <400000>;

      temperature-sensor@4A {
        compatible = "ti,tmp100";
        reg = <0x4A>;
        vs-supply = <&vcc_3v3_sys>;
      };

};

But unable to get the i2c address of the temperature sensor. Then the lm75.c and lm75.h files are already included in our device tree. Could you please let me know if there is any solution for this?

0 HarryG over 1 year ago in reply to SRIDHAR P

TI__Expert 7070 points

Hello Sridhar,

My best recommendation would be to contact the team developing the AM62 (should be the Processors team on E2E) as they will be better suited to answer this question.

Regards,

Harry

Sensors

Sensors forum

TMP100: Read data from the temperature sensor