• State TI Thinks Resolved
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 32 subscribers
  • Views 95 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

Original question:

LDC2114: LDC2114EVM and GUI software 1.10.0

LDC2114: LDC2114EVM and GUI software 1.10.0

kari.makelainen
Prodigy 40 points
Part Number: LDC2114

Tool/software:

Continuing to the previous communication, I ordered new evkit and it has the same issues.

Device is detected and operational but any change will cause the evkit to disconnect after I set the CONFIG_MODE bit to 0.

There seems to be no change with the new evkit, operation remains the same.

  • 0
    TI__Mastermind 38875 points

    Kari,

    I am sorry to hear you are having problems with the EVM & GUI.

    it looks like the LDC2114 EVM User's Guide has two possibilities for changing device settings. 

    Following the steps called out in section 4.6.2 allowed updates the CONFIG_MODE bit of the RESET register without the board disconnecting.

    Section 4.7 describes use of the Configuration page change device settings, which seems to work.

    Please let me know if you have any questions.

    John

  • 0 in reply to John Miller - Sensing
    Prodigy 40 points

    Seems like there is something wrong with the access rights of the nw.exe that is causing these errors. When I installed the software to my home computer, it requested some right for Defender settings that are not allowed in my company PC I will continue searching someone who could help with this.

  • 0 in reply to kari.makelainen
    TI__Mastermind 42450 points

    Kari,

    John is out of office right now.  Thanks for the update.  Hopefully, your IT department is able to provide the access rights required.  I am going to close this thread for now, but let us know if anything else is needed.